ReturnHP 
Contents
2.2.4 [Cut] command
The object chosen is cut off.
TOOL
 

When starting this command, the command which was starting before it is automatically ended. A procedure is shown below. It is copied by command starting after object selection. (refer to The way of choosing object) The cut off object can be stuck on arbitrary positions with [Paste] command.
Since the copied object is outputted to a permanent residence file (common use) and is held, the time of starting, and even when JCAD3 is started separately, the same data can be pasted next time.
The object with which the [Cut] command copied after the cut is deleted. The [Copy] command is used to hold.






 
 Copyright 2009 GLB Co., Ltd All Right Reserved