2.7.14 ［テキスト］コマンド

Generate a Text object

TOOL

When starting this command, the command which was starting before it is automatically ended and the curved surface
which was put in the thickness becomes a chosen condition (red display)
A procedure is shown below.
1. It starts [Text] command.
2. The [Text] Dialog is displayed.

[Text]Dialog
The following information is set up. A push on the O.K. button generates Text Object.

(a) Font - The font name of a text object.
The font which is not displayed cannot be used although there are some which are not displayed in a dialog in the
font actually installed.
(b) Text - The text character of a text object.
(c) Height - A height of the 1st character of a text object. (Fig:A)
(d) Thickness - A thickness of the 1st character of a text object. (Fig:B)
(e) Interval - A interval of the 1st character of a text object. (Fig:C)
(f) Reverse - The front reverse side of a surface is reversed.
Please check,when you check the front reverse side of a field and it is turned over on the perspective.
The menu (curved surface edit) into which a control point is edited cannot be used.