It generates the sweep form the section shape of which is more than one which is chosen piece of object (Wire).。

TOOL

Function Key
no-function Key	Usually, Wires Sweep
F5 key is pushed and it is command starting.	Facet
F6 key is pushed and it is command starting.	1 Section

When starting this command, the command which was starting before it is automatically ended and the generated sweep
body becomes a chosen condition (red display).
A procedure is shown below. (It does any one of three planes (X-Y, Y-Z, Z-X).)
1. It chooses more than one the objects (Wire). (For the details, refer to The way of choosing object.)
It makes the object (Wire) which it is possible to choose the following condition.
(a) The number of the choice object is 2-10.
(b) The boundary condition (Open/Close) and the number of the Control points make identical in all objects.
2. When [Wires Sweep]command is done with [Facet].
F5 key is pushed, and the [Facet] mode is taken.
3. When [Wires Sweep]command is done with [1 Section].
F6 key is pushed, and the [1 Section] mode is taken.
Facet and 1 Section cannot be started simultaneously.
4. It starts [Wires Sweep] command.
Solid Facet can be set up if a function key is pushed. refer to Solid and Facet.